TECHNICAL SPECIFICATION
• Solderless Breadboard:
▪ Interconnected nickel plated contact with 1680 tie-points
• Variable DC power supply: ±3VDC ~ ±18VDC/0.5A
• Fixed DC power supply : ± 5VDC/1A
• AC Supply: 12V-0-12V/500mA
• Function Generator: (5 ranges )
▪ Frequency Range: 1Hz ~ 10Hz
10Hz ~ 100Hz
100Hz ~ 1KHz
1KHz ~ 10KHz
10KHz ~ 100KHz
▪ Output Waveform (with amplitude control):
•
Sine wave (12Vpp.)
•
Square wave (12Vpp.)
•
Triangle wave (12Vpp.)
• Variable resistors: 1KOhm (each), 10KOhm(each)
• Digital Multimeter:
▪ Display: 3.5 digit LCD
▪ DC Voltage: 200 mV/2V/20V/200V/1000V
▪ DC Current: 2000μA/20mA/200mA/10A
▪ AC Voltage: 200V / 750V
▪ Resistance: 200Ω / 2KΩ / 20KΩ / 200KΩ / 2000KΩ
▪ Continuity Tester
▪ Transistor Tester
• Portable robust metal case form factor
• Input Supply: 240VAC/50Hz
• On/Off Power Switch with Indicator
• Fused protection
TECHING MODULE SPECIFICATION
OPERATIONAL AMPLIFIER 1 - Model: OP-AMP-01
• Introduction to Operational Amplifier (Op-Amp)
• Op-Amp theory and characteristics
• Inverting Amplifier
• Non-inverting Amplifier
• Voltage Follower
• Summing Amplifier
• Subtractor
• Integrator
• Differentiator
• Measurements of op-amp parameters: open loop voltage gain, input offset voltage, input offset current
• Op-Amp Input Modes (Differential, Single-Ended, Common Mode)
• Inverting and Non-inverting Inputs
• Inverting and Non-inverting Amplifiers
• Faults switches simulation
OPERATIONAL AMPLIFIER 2 - Model: OP-AMP-02
• Comparator
• Voltage DIvider
• Inverting Schmitt Trigger
• Non-Inverting Schmitt Trigger
• Op-Amp as Positive Clipper
• Op-Amp as Negative Clipper
• Op-Amp as Positive Clamper
• Op-Amp as Negative Clamper
• Cascaded Amplifier using Op-Amps
• Using Op-Amp as Instrumentation Amplifier
• Faults switches simulation
FILTERS & TIMERS - Model: OP-AMP-03
• Op-Amp Low Pass filter(LPF)
• Op-Amp High Pass filter (HPF)
• Op-Amp Band Pass filter(BPF)
• Op-Amp BRF(band reject filter)
• Phase Lock Loop (PLL) Operation
• Bistable multivibrator (555 timer)
• Monostable multivibrator (555 TImer)
• Astable multivibrator (555 timer)
• Faults switches simulation
OSCILLATOR 1- Model: OP-AMP-OSC-01
• Op-Amp Bistable multivibrator
• Op-Amp Monostable multivibrator
• The Square Wave Relaxation Oscillator
• Variable Duty Cycle
• The Phase Shift Oscillator
• The Wien Bridge Oscillator
• The Triangular Waveform Oscillator
• Faults switches simulation
OSCILLATOR 2 - Model: OP-AMP-OCS-02
• The Crystal Controlled Oscillator
• The Hartley Oscillator
• The Colpitts Oscillator
• The Twin “T” Oscillator
• The Clap Oscillator
• Faults switches simulation
MANUAL & ACCESSORIES
• Operation / User Manual x 1
• Lab Experiment Manual (with answer) x 1
• Power Cord Cable x 1
• Connecting Lead x 1
• Spare Fuse X 2
